Field Controls 12 Draft Oil-Gas-Wood-Coal MGII-12
A double-acting control for gas-fired furnaces and boilers is widely used for conversion burner installations, gas draft-induced appliance operation with mechanical draft inducers, or sidewall power venters. It is also recommended for use on gas atmospheric appliances where a draft hood cannot be installed, and can improve combustion stability and draft on many gas atmospheric installations with venting problems.
The MGI provides precise, accurate control of drafts at levels higher than permitted by a standard draft diverter, which is a frequent requirement with gas. Because it is double-acting, it opens out to relieve positive vent system pressures as low as .01. Draft adjustments using weights are simple and accurate from .01 to .1. Made in the USA.
Share
Spec Sheet
Field Controls 12" Draft Oil-Gas-Wood-Coal MGII-12
Write a Review
|
Questions & Answers (0)
Product Description
PRICE
$535.00
1
1
Ships in 2 Business Days
Add or Change Zip Code(s)
Easy online or call-in returns. Read return policy
Specifications
Key Specifications
| Width | 11 in |
| Brand | Field Controls |
Weights & Dimensions
| Height | 14 in |
| Weight | 11.2 lbs |
| Circumference | 34-1/2 to 37-3/4 in |
| Diameter | 11 or 12 in |
Product Details
| Length | 15 in |
| Manufacturers Part Number | MGII-12 |
Warranty
| Warranty | 1 yr |
Related Products
X
Mitco 265-12AM Micro-Flow Replacement Oil Filter Element, W/Gaskets, 12/Pk State of the art oil filter cartridges designed for a full range of nozzle gallonages. Largest surface area with the most flutes - computer designed. Largest volume of filter material. increased holding capacity provides larger area for longer filter life. Non-shedding design is fiber welded - no bonding agent to clog nozzle. Revolutionary Y fiber improves depth filtration. Replaces General 2A-700A, Sid Harvey 265-12A. Made in the USA.
X
Field Controls 8 Power Venter 740,000 BTU SWG-8 Patented SWG Venter is ETL and cETL listed for all LP gas, natural gas, or oil-fired heating equipment. Combines the motor, blower, and vent hood in one complete, easy to install unit. The SWG mounts on the outside of the building and pulls the combustion gases from the appliance through the outside wall utilizing 100% negative pressure. Made in the USA. Benefits: 100% negative pressure in the vent pipe for maximum safety. Standard galvanized pipe can be used instead of expensive stainless steel. No need to seal vent pipe joints, saving time ...
X
Features: Simple direct coupling reduces installation and commissioning time while improving reliability by eliminating damper linkages Robust 140 lb-in (16 Nm) torque rating Rotation range 0 to 90° in 5° increments, mechanically limited to 93° Fits 3/8 to 3/4 (10 to 20 mm) round shaft, 3/8 to 5/8 (10 to 16 mm) square shaft; 1 (25.4 mm) diameter jackshaft with M9000-154 adapter On-off, floating and proportional control inputs meet the needs of most applications Output position feedback provides simple closed-loop control with accurate position sensing Master/slave operation ...
X
The Fan-in-a-Drum® is a commercial product designed to deliver combustion air into the mechanical room, boiler room or furnace location to overcome a confined space or inadequate air supply. Dual volt unit for oil or gas applications. When the thermostat calls for heat, the Fan-in-a-Drum® engages and begins drawing air into the structure. When air flow is established, the pressure switch closes. The CAS sends a signal to the appliance, allowing the burner to fire. The Fan-in-a-Drum® diffuses the outside air into the room near the burner to ensure adequate air for efficient combustion. ...
X
The M9208 Series Electric Spring Return Actuators provide control of dampers in Heating, Ventilating, and Air Conditioning (HVAC) systems. All actuators in this series provide 70 lb·in (8 Nm) rated torque. A mechanical spring return system provides rated torque with and without power applied to the actuator. The series includes the following control options: On/Off, 24 V, 120 VAC, 230 VAC power On/Off and Floating Point, 24 V power Proportional, 24 V power, for 0(2) to 10 VDC or 0(4) to 20 mA Control Signal These actuators are configured for direct mounting and do not require a damper ...