80/20® Flex pipe Standard Tee Joint, Steel, Black

The H-14 is a metal single joint used to assemble the HJ-14 joint set. This product will form the base of a double pivot connector for use in many situations. To make an HJ-14, you will have to group two H-14 and connect two pairs of H-6 to it. The H-14 is not a multi-purpose or even a favorite single connector. Its job is only to make an HJ-14.

The H-4 is a metal single joint needed to create joint sets known as HJ-3 and HJ-4. This joint is mostly used to create joints that work best in the center of structures. Since this metal piece is part of the HJ-3, which is a critical connector. This part will not be used as much as the three first Hs. The H-4 was built with six internal striations for optimal grip on the pipe's outer coating. This connector was also pre-drilled with three holes for the reinforcement of heavy-duty structures. The product comes in a nickel-plated version called H-4NP. This version will be necessary when ...

The H-6ANP is a chrome plated single joint with antistatic properties (ESD) used to assemble the HJ-6ANP joint set. This part is used to create joint sets with a high rotational capacity. The HJ-6ANP allows the largest corner radius of any Flexpipe joint sets. Technical Informations: This connector is designed with 2 striations for a better on the plastic coating of the 28 mm pipes. The H-6ANP Flexpipe joint is compatible with many other pipe and connector systems.

The 2 hole - pivot joint is an external fastening method that is lightweight yet sturdy. This connector mounts to the end of a profile, which requires an end tap. The screws on the arms can be adjusted for movement or fixed in one position. The suggested hardware for the 2 hole - pivot joint can be found on the "Suggested Hardware" tab.

The H-5NP is a anti-static metal single joint used to assemble the HJ-6NP Flexpipe joint set. This connector can also be grouped with another H-5NP to connect a pipe and a surface. The main difference between using this technique and using the HJ-15NP connector is that the surface will be aligned with the pipe center and not the tube's edge when using the HJ-15NP. The H-5NP was designed with two internal striations for greater grip on the pipe's outer coating. Be sure to reinforce the H-5NP if you are using them to support a surface. This can be done easily with two F-A858 screws.