Baldor-Reliance Brake Motor, EBM3313T, 3 Phase, 208-230/460 Volts, 10 HP, 1770 RPM, OPEN, 215T Frame

Baldor-Reliance Motor, 10HP,1800RPM,3PH,60HZ,254TC,TENV,FOOT, Features: Designed specifically for Inverter operation where up to 1000:1 constant torque speed range is required Includes provisions for stub shaft for hollow shaft encoder, three thermostats, and all 440T frames include an ODE insulated bearing Insulation system exceeds NEMA MG 1-2006, Part 31.4.4.2 Continuous constant torque to zero speed Typical Applications: Conveyors, extruders, printing lines, converting, test stands, anywhere constant torque is required over a wide speed range.

Baldor-Reliance Permanent Magnet Motor, CSPM3546T, 3 PH, 230/460 V, 1 HP, 1800 RPM, TEFC, 145TC Frame The Definite Purpose family of motors captures a host of variety demanded by the marketplace. These motors include TEFC and ODP Two-speed motors, as well as single phase Pressure Washer motors. This group of specialty motors includes Arbor Saw to Woodworking, Pre-1952 NEMA motors to SAE Hydraulic Pump motors. An extensive line of TEFC and ODP F-2 motors are available as well in 1 Hp through 60 Hp. The Automotive Approved motors, approved by major US automobile manufacturers, are available ...

Severe Duty motors are available from 1 HP to 700 HP. These products are especially designed for those applications requiring protection of the motors from severe environmental operating conditions. A few typical applications which might require these types of motors include petro-chemical plants, mines, foundries, pulp and paper plants, waste management facilities, rock crushers, and chemical plants. Features Super-E premium efficient motor 1.15 Service Factor Corrosion resistant epoxy finish Regreasable ball bearings Oversized rotatable cast iron conduit box Forsheda® shaft seal ...

Baldor-Reliance Motor, 7.5HP,1770RPM,3PH,60HZ,213TC,0735M,TEBC Features: Full torque at zero speed 1000:1 constant torque range Totally Enclosed Non Ventilated (TENV) or Totally Enclosed Blower Cooled (TEBC) 1/3 thru 500 horsepower Cast Iron construction C-Face with base 143TC thru 449TC Base mount only in frames 5007L-5009L Class H Insulated ISR® (Inverter Spike Resistant) magnet wire Meets NEMA MG 1, Part 31 Typical Applications: Test stands, material handling, packaging equipment, printing presses, etc. Applications requiring adjustable speed operation with full torque from zero to ...

Baldor-Reliance Motor, 7.50HP,1773RPM,3PH,60HZ,213TC,TEFC,FOOT Features: Designed specifically for Inverter operation where up to 1000:1 constant torque speed range is required Includes provisions for stub shaft for hollow shaft encoder, three thermostats, and all 440T frames include an ODE insulated bearing Insulation system exceeds NEMA MG 1-2006, Part 31.4.4.2 Continuous constant torque to zero speed Typical Applications: Conveyors, extruders, printing lines, converting, test stands, anywhere constant torque is required over a wide speed range.