Keysco Hinge Aligner, Steel, 3-1/2"W x 3-1/2"D x 27"H

The HJ-12NP is a hinge anti-static connector that allows a pipe to rotate 360 degrees around another perpendicular pipe. This feature enables the creation of a multitude of rotating modules on Flexpipe structures. We use this hinge joint at Flexpipe to build doors, movable separations, and folding shelves. If you don't use a stopper on any rotating pipe, you can also slide the fitting onto this pipe and create different setups for separations. If you need to prevent sliding, be sure to take a look at the tips and tricks section of this product page. This hinge will give you the option of ...

The Keysco Heavy Duty Push-Pull Body Mate is an eleven piece jack set. It is a compact and powerful jack set for use in those knuckle busting areas. Designed for pushes and pulls of front end work, roof bracing, rails and bumper alignment. The universal application allows it to be used anywhere on the car. All of the friction rod and jack parts are hardened steel and all attachments are fully plated.

The Keysco 6 foot Van Stand is a heavy duty stand designed to give you easy access to high off the ground engine compartments. This stand is similar to the Kesco 4 foot Van Stand, but with more height and width for larger vehicles that require under the hood services. This stand is safety yellow with non-skid surface tape to ensure that no accidents are had while performing service on your van or truck.

The Keysco Monkey on a Stick is a friction jack set designed for pushing and pulling up to 3,000 lbs. Features a 55 inch long solid alloy 3/4 inch diameter rod, which eliminates the need for extension tubes in hard to reach areas. This is the most versatile tool available, it pushes, pulls, aligns, spreads and straightens.

The Keysco Deluxe Bumper Stand is a complete bumper system that includes support tubes, padded hoop & padded u-shaped brackets. This will swivel 180 degrees while holding the entire bumper securely, and adjusts up and down, in and out. Works on the outside and inside of any bumper. The tubes extend to firmly hold the "floppy ends" of plastic bumpers.