K2® Tethered Float Switch For Sump Pits and Basins, 125 Volt, 13 Amps

The "SinkWire" Float Switch Connection Kit is a must for connecting any float switch where the wiring connections are subject to wet conditions. Many float switches fail because water enters the switch through the wiring. Using the "SinkWire" Float Switch Connection Kit ensures that your float switch will last through the years. Each kit contains (2) Black Shrink Wrap Connectors for "No-Connect" Wires, (2) 9mm Black Shrink wrap tubing used for water prevention over SO cord jacket, (4) 14-16 AWg Shrink Connectors for Single End to End Connections, (2) 10-12 AWG Shrink Connections For ...

The "SinkWire" Float Switch Connection Kit is a must for connecting any float switch where the wiring connections are subject to wet conditions. Many float switches fail because water enters the switch through the wiring. Using the "SinkWire" Float Switch Connection Kit ensures that your float switch will last through the years. Each kit contains (2) Black Shrink Wrap Connectors for "No-Connect" Wires, (2) 9mm Black Shrink wrap tubing used for water prevention over SO cord jacket, (4) 14-16 AWg Shrink Connectors for Single End to End Connections, (2) 10-12 AWG Shrink Connections For ...

This Unit Has a Piercing 120 dB Siren, Self-Charging LiPo Battery Powers the Sump Alarm During Outages for up to 1 Week. This Sump Pump Monitor is Intended for Indoor and Clear Water Applications Only. It Features Built-in Test and Silence Capabilities. Ideal for Those Who Want to Forgo a Complicated Wi-Fi Setup, This Sump Pump Alarm Straps Directly to the Discharge Pipe with Included Mounting Accessories. Its Float Switch with 15 Ft. Cord Will Not Interfere with Sump Operation. It Comes Ready to Install with a Power Cord and Float Switch Bracket that Set up in Just a Few Minutes. This ...

This Sewage Float Switch and Septic Float Provide Reliable Measurement and Control of Wastewater Levels for Both Empty and Fill Applications. With its 16 Foot Cord and Self-Orienting Design Non-Tethered to Accommodate an Array of Needs, This Float Switch is Ideal for Medium to Heavy Amounts of Suspended Solids Designed for Sewage and Septic Applications. The SludgeBoss Float Switch is Controlled by a Honeywell Micro Switch and is Rated for Use with 12-24VDC and 120-240VAC. Directly Control Motors of up to ½ Horsepower (or 13 Amps) at 120- or 220-Volts AC for Non-Continuous Pump ...

The mercury free liquid level control has a piggyback plug molded toThe cord allowingThe pump motor to plug intoThe cord andThen plugThe entire assembly into a standard grounded outlet. Designed for use with AMT Submersible Pumps 1 1/2XT33, 02XH5 and 02X11. Features: 30 Ft. long 16 gauge cord with 115V plug 15 Amp Mercury-free No field wiring required Adjustable clamp Corrosion resistant Proven reliability Omni directional Variable pumping range Easily installed