Benchmark Scientific Tube Rack for BenchMixer XL & XLQ, 15 x 25mm

This innovative line of plastic test tube racks are shipped flat in order to reduce shelf space and then simply snap together for use. The special design allows all samples to be incubated at the same temperature. These racks can be used in freezers without deforming or going brittle. They will not rot, rust of deform. Alphanumeric markings are molded into the racks to provide easy test tube identification. They are available in assorted colors for sample coding or aesthetics. Features Polypropylene (PP) Autoclavable Non-floating in water baths Stackable when empty

Features Fully Autoclavable Molded from reinforced nylon for strength and durability with no coatings to chip, peel, or rust Single piece, three (3) tier grid design for secure and stable racking of tubes Good temperature and chemical resistance to withstand a variety of lab procedures Large, flat endplates for labeling and easy sample identification Dense nylon material will not float in water bath 15mL conicals fit in 20mm racks and 50mL conicals fit in 30mm racks Seven colorful options to keep samples and benchtop organized

Polyethylene rack features six openings, each 25 mm in diameter, and six drying pins. Designed with fully open sides for clear viewing. Assembly required.

This hack holds 7x50ml tubes horizontally. UsefulQuechers applications. This foam sheet fits both the Benchmark BenchMixer XL and XLQ. No holes - can be used to hold flat bottomed containers or as a replacement for the top foam. This tube rack hold 96 x 0.5ml tubes (8mm diameter). For use with the Benchmark BenchMixer XL and XLQ.This tube rack holds 50 x 1.5/2.0ml tubes (10mm diameter). For use with the Benchmark BenchMixer XL and XLQ.This tube rack holds 50 x 12mm diameter tubes. For use with the Benchmark BenchMixer XL and XLQ.This tube rack holds 50 x 13mm diameter tubes. For use with ...

The CoolCube is designed to store samples safely on the lab bench without sample degradation due to temperature increase or fluctuation. Simply place the CoolCube in the freezer overnight and it's ready for use, keeping samples cold, but not frozen. One side of the CoolCube will hold 36x1.5/2.0ml tubes. Flip it over, and you have a PCR workstation. This side holds one 96 well PCR plate (or 96x0.2ml tubes) and ten 1.5/2.0ml tubes. CoolCube maintains temperature at approximately 0° C for up to four hours.