Yellow Speed Bump with Cable Protection & Hardware - 48" Long

A spiked speed bump is an easy way to control the movement of traffic, while deterring vehicles from entering and exiting in the same lane. With a retractable spiked design, the speed bump allows traffic to flow only in a single direction. When the vehicle enters in the correct direction the spikes will submerge into the construction of the bump allowing the vehicle to pass unobstructed. If the vehicle were to exit using the same lane, the spikes will not retract but continue to stand tall. Features: Connectible to additional spiked speed bumps Galvanized spikes Crossable at a maximum of ...

✓ Impressive max capacity limit of 66,000 lbs. ✓ Suitable for both indoor and outdoor use. ✓ Easy to remove, transport, and install. The Global Industrial™ Portable Rubber Speed Bump is built for maintaining and controlling vehicles in high-traffic areas. Measuring at 48", this portable speed bump is made of UV rubber that absorbs impacts from vehicles of various weights, making it a perfect choice for parking lots, shipment yards, and more. The max capacity is 580 lbs. per square inch or 66,000 lbs. This speed bump requires 4 spikes. The end caps (sold ...

PROTECTIVE 72 INCH LONG PARKING CURB This parking curb stops cars in their tracks. Designed with safety and durability in mind, this parking curb withstands repeated abuse from cars and trucks. Made of high density polyethylene that is weather, chemical and UV resistant. Parking stop is flexible enough to fit parking lot contours. Includes hardware for installation. This item can be installed in asphalt or pre-drilled concrete before installing (Rebar spikes are 1/2 Inch outer diameter). Measures 72"L x 8"W x 4"H.

✓ Weight capacity of 20,000 lbs ✓ Non-skid surface resists weather, UV, and chemical damage ✓ Accepts cords, cables, and various lines The Global Industrial™ Speed Bump with Cable Protection allows air lines, water lines, and electrical lines to run without the worry of being flattened by vehicles. The versatile design of this speed bump handles the heaviest of vehicle loads while also acting as a dual channel protector. Flexible design fits contour of road or factory floor. The unit is not designed for permanent installation, allowing it to be moved ...

An end cap provides an effective finish to either side of the spiked speed bump. By fitting directly to an existing spiked speed bump, the previously open ends are shored up and contained. Caps are constructed of steel. Features: Sold in pairs 20 ton axle load capacity Pre drilled mounting holes Yellow powder coat finish Plate Thickness (in.): 0-1/4" Hole (quantity): 1 on each side Hole Diameter (in.): 0-1/2" Manufacturer Warranty: 30 Days Warranty Type: Limited - Parts Finish: Powder Coat